All Standard Sizes are 4.5" wide and 12" long and are used with the Standard Template
14 Narrow Vent slots in a standard profile
15 Narrow Vent slots in a standard profile
14 Medium Vent slots in a standard profile
15 Medium Vent slots in a standard profile
14 Full Vent Slots in a standard profile
15 Full Vent Slots in a standard profile
All of the Standard Sizes are offered in a Retro Fit Profile. The hole sizes and count will be the same but the outside profile of the vent is 5"x13". This option is intended for use if the floor was installed previously and the hole was cut too large for a standard size vent.
All XL Sizes are 4.5" wide and 15" long and are used with the XL Template
18 Narrow Vents slots in a XL profile
18 Medium Vent slots in a XL profile
18 Full vent slots in a XL profile
All Wide Sizes are 6" wide and 12" long and are used with the Wide Template
28 Medium vents slots in 2 columns in a wide profile
30 Medium vent slots in 2 columns in a wide profile
All Wide XL Sizes are 6" wide and 15" long and are used with the Wide XL Template
36 Medium Vent slots in 2 columns in a Wide XL profile
There are 3 Drain and Access cover sizes. Each size has a coordinating Template. The Drains have a series of holes. The Access covers are a solid cover with a finger hole to aid in lifting.
Outside dimensions are 4.5 x 5".
Outside dimensions are 6" x 6"
Outside dimensions are 8" x 8"
The Wall Hugger is designed to be used when the air duct is very close to the wall base or at the toe kick of a cabinet. Outside dimensions are 4.5" x 13" and the coordinating Wall Hugger Template should be used for installation.
Custom sizes are available up to 7.5" in width and as long as needed. Custom Templates are available in 5" increments up to 30". Longer custom vents can be produced but the installer will have to adjust the template to cut the appropriate length.
USE WITH ALL STANDARD SIZES. 4.5" X 12" PROFILE
FOR USE WITH 2"X14" AND 4"X14" VENTS. 4.5" X 15" PROFILE
FOR USE WITH 6"X10" AND 6"X12 VENTS. 6" X 12' PROFILE
5" X 13" PROFILE. THIS IS USED WHEN ADDING VENTS AFTER THE INITIAL INSTALLATION AND THE HOLE HAS ALREADY BEEN CUT LARGER THAN THE STANDARD SIZE VENT.
FOR USE WITH FLOOR DRAINS OR ACCESS POINTS
4.5" X 5" PROFILE.
Our Vents are only available through Authorized Dealers.
Check out our Dealer locator page to find your local dealer.
Copyright © 2023 Perfect Vents - All Rights Reserved.
U.S. Patent #'s 10,641,518 and 11,378,302